Product Part Number: 257L050 (4 port)
Product Part Number: 257L049 (16 port)
PC Form Factor: PCI
TDM Bus Type: H.100
Digital Ports: 4 / 16 Basic Rate ISDN S/T Interface
Bus Capacities:
H.100 - 4096 timeslots
BRI - 8 / 32 B Channels
Each of the INS-Net 64 BRI ports provide an S/T interface, and can be configured as either NT (for connection to ISDN phonesets) or TE (for connection to the Central Office). Layer 2 and Layer 3 access is available. The rear panel provides a single SCSI-III amphenol connector which is intended for use with mating cable 251D037. When used with this cable, the sixteen ports will map to two standard RJ21 amphenols. The rear panel of the four port board presents four RJ45 modular interface jacks.
Downloads:
XDS H.100 INS-Net 64 BRI technical manual
Additional Product Specifications
|
BRI Interface: (4 port board) |
|
| 2B channels + 1D channel) x 4 | |
| Four modular RJ45 interface jacks provide direct connection to the board. | |
|
BRI Interface: (16 port board) |
|
| 2B channels + 1D channel) x 16 | |
| SCSI-III adapter cable connects to PCI rear panel to present 16 ports on two RJ21 amphenols. | |
|
Signaling Protocols: |
|
| Layer 2 and Layer 3 messaging: | supported |
| Layer 3 protocol stacks: | INS-Net 64 |
|
DSP Resources: |
|
| DTMF Detector | (each port) |
| Energy Detector | (each port) |
| DTMF Generator | (each port) |
| all Progress Tone Generation | (each B-channel) |
| 1004Hz Calibration Tone Generation | |
| 32 Bi-directional voice resource channels | |
|
Temperature Extremes: |
|
| Operating: | 0°C (+32°F) to +50°C (+122°F) |
| Storage: | -40°C (-40°F) to +70°C (+158°F) |
|
Ambient Humidity: |
Designed to withstand ambient relative humidity from 0% to 95% non-condensing in both operating and storage conditions. |
| Other: | |
|
Mechanical: |
Designed to conform to PCI-SIG mechanical specifications for full-length PCI cards. |
|
MTBF: |
50,000 hours |
|
Electrical Requirements: |
+5 volts +5% @ 1.5 amps maximum -48 volts, maximum current per port 100mA (required only for PS1 power option) +12 volts, +3 volts, and -5 volts are not required. |